E-44 Trucks

Discussion relating to the PRR, up to 1968. Visit the PRR Technical & Historical Society for more information.
urrengr2003
Posts: 150
Joined: Wed Sep 15, 2004 6:24 pm

E-44 Trucks

Post by urrengr2003 »

Many (not all) E-44 locomotives have what appears to be a shunt attached to the individual journals from the truck sideframe on the left side of the locomotive only. This does not appear to be a universal application. What was its purpose: a shunt for cab signals or for propulsion return current?

mp15ac
Posts: 295
Joined: Mon Apr 19, 2004 10:05 am
Location: Long Island

Re: E-44 Trucks

Post by mp15ac »

Neither. Those are speed recorders, used for wheelslip control circuits. Some diesel and electrics had them on each axle, usually on one side of the engine, others only had a single one, usually underneath the cab.

Stuart
The light at the end of the tunnel may be the headlight of an on-coming train.

TrainDetainer
Posts: 105
Joined: Mon Dec 12, 2016 5:37 pm

Re: E-44 Trucks

Post by TrainDetainer »

Stuart - I don't think he's talking about axle alternator cables. He's likely referring to the flexible braided wires that bolt directly to the frames and boxes.

Electric locomotives take their hot lead from the overhead or third rail and the return is through the rail/earth ground, so they have to have good electrical continuity from the internal electrical system to the rail. That continuity is compromised by the separate components of the running gear, including separation by grease, dirty oil, etc. The solution is the braided wire to get electricity as directly as possible from the frame to the wheels. In addition to the visible braids from truck frame to journal boxes, there are also heavier braids that connect the main frame to the truck frames. From the journal boxes the electricity must pass through the axle bearings to reach the axle/wheel, but the use of conductive oil in a sealed bearing makes that part relatively reliable compared to centerplates and pedestal openings.

Additionally, the braids are just heavy duty flexible wire, not shunts. An electrical shunt is something different - a resistive bypass usually used in control circuits.

Return to “Pennsylvania Railroad”