Locomotive cabs

General discussion about locomotives, rolling stock, and equipment

Moderator: John_Perkowski

Re: Locomotive cabs

Postby atsf sp » Mon Aug 10, 2015 9:45 pm

SD45 looks like a sd40 interior
"Why would you take a train to go see another train?"
Some people just don't understand.
My Photos
atsf sp
 
Posts: 2178
Joined: Mon Jul 30, 2007 7:00 pm

Re: Locomotive cabs

Postby slashmaster » Mon Oct 05, 2015 9:49 pm

Is this a small perhaps 2 foot gauge locomotive in this pic? It's yellow on the right. https://www.facebook.com/mgtowtechnique ... =3&theater
slashmaster
 
Posts: 447
Joined: Sun Apr 06, 2008 5:09 pm

Re: Locomotive cabs

Postby nyandw » Tue Apr 24, 2018 11:33 am

Some cab shots:http://www.trainsarefun.com/lirr/lirrcab.htm

Image
ALCO C420 control stand c.1968 (Jay Bendersky-Robert Anderson)

ALCO C420 CONTROL STAND

1) Throttle-idle position
2) Dynamic Brake handle-locked out not used
3) Automatic Brake valve-train brake
4) Independent Brake valve-full applied position
5) Head Light switch-rear
6) Head Light switch-front
7) Bell valve
8) Console Light
9) Manual sander valve
10) Console Light
11) Emergency fuel cut off switch
12) Switches-Control-battery-generator field-fuel pump
13) Reverser
14) Air brake gauge-Main Res/Equalizing res
15) Air Brake gauge-Brake pipe/Brake cylinder
16) Air Brake gauge-Supression air
17) Air Brake gauge-Timing Air
18) Amp gauge-Traction
19) Two Horn chains encased in rubber hose-city/country(1)
20) Brake pipe regulating valve
21) ABVCOC (Automatic Brake Valve Cut-Out Cock)
22) Independent brake regulating valve
23) MU2a valve-multiple unit/lead-dead

Note (1): There were two ropes with a length of rubber hose (about 18" each) on them where you would pull them down to sound the horn. One was for the "City" tone, which was lower in volume than the other, "Country" tone which was louder. Both ropes led to separate valves on the cab ceiling. If you grabbed them both together, you could make even more noise.

Further trivia: Because of clearance issues at various locations, the horns were mounted on the engineers side of the car body, on the side (not the top) of the engine, just ahead of the smoke deflectors.
User avatar
nyandw
 
Posts: 3300
Joined: Fri Mar 19, 2004 12:41 am

Previous

Return to General Discussion: Locomotives, Rolling Stock, and Equipment

Who is online

Users browsing this forum: No registered users and 1 guest