Milwauke GP20 Info

Discussion of Electro-Motive locomotive products and technology, past and present. Official web site can be found here: http://www.emdiesels.com/.

Moderator: GOLDEN-ARM

Re: Milwauke GP20 Info

Postby JayBee » Fri Dec 07, 2012 6:57 pm

Paul wrote:Just for the record, my GP-20 has a 645E and D-22 MG. Now, how many knew that EMD marketed a "645C", that being an "E" block manufactured with 567 packs? BTW, just slamming in 645 packs into a 567 does not change the engine rating or classification.


Never heard of EMD building a 645C, For the record EMD locomotives do not have a block, and beginning with the letter "A" each change of letter refers to a redesign of the fabricated crankcase. EMD built a significant number of locomotives with 567E diesels, these were SW1200s built for MP, T&P, SP, and SSW, after EMD had begun building road locomotives of the 40-series with 16V-645E3 diesels and the engine fabrication line had been converted from building "D" to "E" series Crankcases. It made no significant difference in the locomotives. BN and other railroads and rebuilders used the nomenclature of "645C" and "645D" to identify which type of power assemblies and what Crankcase type was in use in any particular diesel engine.

Union Pacific converted a large number of GP9s to a turbocharged version later referred to as an "Omaha GP20s" this work predated EMD's development of their own GP20, though the name may not have. See here

http://utahrails.net/articles/up-gp9-turbo.php

EMD Order numbers are stamped into the frame side sill on the Engineer's side right behind the step well, and diagonally opposite on the rear. This is the Order and Frame number, and not the serial until the middle of 1971 when EMD changed its serial number system. Locomotives built in Canada and a few oddball types lack these numbers until the 60-series were built.
JayBee
 
Posts: 353
Joined: Thu Oct 27, 2011 11:28 pm

Re: Milwauke GP20 Info

Postby Engineer Spike » Sat Sep 02, 2017 9:21 pm

The serial number plates on some CPR GP9s, which I have been on were restamped 645C. This must describes a C crank case, with 645 pistons and liners.

When Milwaukee did the GP20 program, or even the UP turbo tests, did they use the original MG, or was a bigger one needed?
"Welcome all ye who enter; the show that never ends. Tingfield Sperminal Railway." (Graffiti on the entry to Mohawk Yard Office)
Engineer Spike
 
Posts: 1645
Joined: Tue Mar 16, 2004 3:24 pm

Previous

Return to EMD - Electro-Motive

Who is online

Users browsing this forum: No registered users and 3 guests